Interior parts and seats

Armrest

Armrests are formed as much by their fixation points as by the door environment: consequently, a complete armrest checking fixture must simulate both characteristics to check the part in conditions as close as possible to the part fitting in the car.

More info

Dashboard assembly

Dashboards can be checked by two control processes: 1. by CMM machine during the prototyping steps. The part is fixed on a CMM fixture that simulates the part datums for its fastening during the measurement process. 2. By a cubing-type checking fixture, for the mass-production steps. This checking fixture simulates the fitting conditions of the part on the car.

More info

Door pocket

A series of characteristics that can be controlled as much by Go/No Go controls as by dial indicators have to be checked on door pockets in order to ensure their proper fitting on the car doors.

More info

Upper pillar trim

Page under construction

More info

Glove box

Page under construction

More info

Roof

Several options of control – varying in terms of complexity, control method and budget – are available to control the largest parts of the car: as much checking fixtures with Go/No Go controls and/or dial indicator control points as solutions of control by artificial vision, like CAPTOR-R.

More info

Dashboard console frame

Page under construction

More info

Seat sliding rail

Page under construction

More info

Air Duct

Check of the part mountability by simulating the car environment fitting of the part. Check of the outer edge of the air inlet and outlet holes.

More info

Sunvisor

Page under construction

More info

Ventilation grille

Page under construction

More info

Seat plastic rear cover

Page under construction

More info