Handbrake reinforcement

Control of the deformation and of the punched holes of the part by Go/No Go pins or dial indicators. This control is essential to make sure that all the elements of the reinforcement assembly after the welding process.

Our checking fixtures are produced in aluminium, the components submitted to wear-and-tear are produced in steel. Tolerances for RPS (fixation points) and dial indicator points: ±0.05mm. Tolerances for simulation blocks: ±0.1mm.

Minimum documentation: dimensional report of your checking fixture, 2D assembly drawing, assembly CAD. Optional documentation: R&R report, user manual, stabilization certificate.

Complete Go/No Go checking fixture for handbrake reinforcement assembly
  • Control of LHD and RHD versions
  • Control of the part deformation and of the location of the holes by Go/No Go pins
  • Identification of the different control areas by colour codes
Checking fixture for clic fit housing
  • Fixation of the part by two sliding systems positioning the part in the middle of its fixation plane.
  • Control of the part deformation and of the location of the holes by Go/No Go pins
Checking fixture for handbrake reinforcement component
  • Fixation of the part by conic centring elements and clamps
  • Control of the deformation and of the location of the holes by Go/No Go pins

Contact us for more information

    *Name

    *Company

    *Email

    *Phone-number

    Subject

    *Message

    Scroll to Top